Skip to content
Anaheim Air
Schedule service
Maintenance

A service visit that ends with numbers on paper

Capacitor values, refrigerant pressures, temperature splits, amp draws. A maintenance visit here is a set of measurements against spec, written down, kept on file, and compared to last year's.

Package unit on a shingle roof during a maintenance visit
Our crew's photo · a package unit on a maintenance visit

What actually gets done

The scope is written. This is what is on it.

01 / Electrical

The two parts that kill systems

Capacitors and contactors die slowly and measurably. A drifting capacitor caught in April is a small fix instead of an August emergency.

02 / Refrigerant

Pressures against spec

Charge checked against the manufacturer's numbers. Low means a leak worth finding now. R-410A costs too much per pound to keep topping off.

03 / Airflow

Filter, blower, coil

Airflow is half of every efficiency complaint. The blower gets cleaned, the coil inspected, and the filter schedule set to your actual dust instead of a generic month count.

04 / The difference

Written down, every time

You get the readings, this year next to last year's. Drift shows up in the numbers years before failure does. That is the entire point of maintenance, and a checklist without numbers is theater.

05 / Heat side

Heat exchanger and ignition

Burners, flame sensor, safeties, and a camera on the heat exchanger before winter. The furnace gets the same measured treatment as the cooling.

06 / Buildings too

The same visit, on a roof

Rooftop units and walk-ins get the same measured treatment on a written scope per unit. One contract, every asset on the site listed, and a report after each visit.

Contracts

Twice a year, before the seasons

Cooling checked before summer, heat before winter, the same technicians each time, and a file that gets longer every year.

01
Spring
Cooling-season prep: electrical, charge, airflow, condensate. The failure modes of July, checked in April.
02
Fall
Ignition, safeties, heat exchanger. First cold night, no surprise.
03
The file
Your system's history in one place, which makes every future diagnosis faster and every repair-or-replace decision honest.
04
The front of the line
When something breaks anyway, contract customers go to the front of the queue. August is kinder from up there.

Questions we get about contracts

On a five-year-old system it is mostly cheap insurance and a small utility-bill trim. On a twelve-year-old one it is how you avoid replacing it during a heat wave. If we think a visit is not worth your money, we will say that too.

The bargain tune-up exists to find your replacement; ours exists to produce readings. Ask whoever shows up for the numbers. If there are none, it was a sales call.

Never, in a tight system. It is a sealed loop. If it is low, there is a leak. A system that “needs a yearly top-off” is a system with a leak nobody fixed.

Cooling in spring before the first heat wave books everyone, heat in October. If you are reading this in July, book anyway. The visit is worth the same, the wait is just longer.

Rooftop unit on a flat commercial roof after a maintenance visit

Get on the schedule

Tell us the system's rough age and when anyone last looked at it. We set the scope and the season, and the price is in writing before the first visit.

2 visits
Typical year
Written
Findings
C-20
Licensed & insured